CHASSIS
7.67
BRAKE
PEDAL
REMOVAL
Remove the cl~p
'1).
Remove the cotter pln
(2)
and washer
(31
Remove the master cylinder rod pin
a).
Remove the brake pedal pivot bolt
(51.
Remove the return spring
iC>
and rear brake switch spring
(7')
from the brake pedal
Wi.
INSTALLATION
Apply grease to the oil seal and brake pedal pivot bolt.
99000-25010:
SUZUKl SUPER GREASE "A"
(or
equlvalent grease)
I
Install the return spring and rear brake switch spring properly.
(-9-26)
Tighten the brake pedal pivot boll to the specified torque.
Brake pedal pivot bolt: 29
N.m (2.9 kgf-rn, 21.0 lb-ft)
Install cotter pins and clip.
~TZTN~
Replace
the
removed cotter pin
with
a
new
one.
Adjust
the brake pedal height.
(-2-19)
,
--..
1.
.2:
To Next Page
Loading...
