7.60
CHASSIS
BRAKE CALIPER REASSEMBLY AND
INSTALLATION
Reassemble and install the brake caliper in the reverse order of
removal and disassembly. Pay attention to the following points:
Clean the caliper bore and piston with the specified brake
fluid. Thoroughly clean the dust seal grooves and piston seal
grooves.
Specification and
classificatlon: DOT
4
CAUTION
I
"
Clean the brake caliper components wlth fresh brake
fluid before reassembly.
*
Do not wipe the brake fluid off with a rag after clean-
ing the components.
When cleaning the components, use the specified
brake fluid. Never use different types of fluid or
cleaning solvents such as gasoline, kerosine or oth-
ers.
Replace the removed piston seals and dust seals
wlth new ones.
*
Apply brake fluld to all of the seals, brake caliper
bores and pistons before reassembly.
PISTON SEALS
Install the piston seal
(I),
dust seal
(21
and 0-r~ng
131
as shown
In ~llustration.
BRAKE
CALIPER
HOLDER
Apply SUZUKl SILICONE GREASE to the brake callper
.
-.
holder pln and callper holder sl~de pin.
&
99000-25100:
SUZUKl
SILICONE GREASE
C
\.
To Next Page
Loading...
