ELECTRICAL SYSTEM
8-29
BATTERY
SPECIFICATIONS
!I.:
Upper cover breather
'51
Terminal
:2:
Cathode plates
16)
Safety valve
(3)
Stopper
17'
Anode plates
(4)
Filter
18)
Separator (Fiberglass plate)
Type designation
I
FTX7A-BS
INITIAL CHARGING
Filling electrolyte
Capacity
Remove the aluminum tape
ti)
sealing the battery electrolyte
filler holes
!A).
NOTE:
When filling electrolyte, the battery must be removed from the
vehicle and must be put on the level ground.
12
V,
21.6
kc
(6
Ah)/lO
HR
Remove
the
caps
(2).
NOTE:
After filling the electmlyfe completely, use the removed cap
(2,
as sealing caps of batlery-filler holes.
Do not remove
orpierce the sealed areas
'3;
of the electrolyte
container.
Insert the nozzles of the electrolyte container
(4)
into the bat-
tery's electrolyte filler holes, holding the container firmly so
that it does not fall. Take precaution not to allow any of the
fluid to spill.
Make sure air bubbles
6)
are coming up each electrolyte con-
tainer, and leave in this position for about more than
20
min-
utes.
To Next Page
Loading...
