Suzuki LT-R450K6 - Master Cylinder Reassembly and Installation

PISTON AND RUBBER PARTS
Inspect the
p~ston surface, prlmarylsecondary cup and dust boot
for any scratches, wear or damage.
If any defects are found,
replace the
plston set w~th a new one.
st'::;
.--
wr~(rn'(\\
MASTER CYLINDER REASSEMBLY AND
INSTALLATION
Reassemble and install the master cylinder in the reverse order
of removal and disassembly. Pay attention to the following
points:
EA@T~
'Clean the master cylinder components with fresh
brake fluid before reassembly.
Do not wipe the brake fluid off after cleaning the
components.
'When cleaning the components, use the specified
brake fluid. Never use different types of fluid or
cleaning solvents such as gasoline, kerosine or
oth-
ers.
' Apply brake fluid to the cylinder bore and all the
component to be Inserted into the bore.
fi Specification and classification: DOT 4
Align the convex part (A) of brake switch with the hole iB, of
master cylinder when installing the brake switch.
&.
@, , ,, ,
' \
..-,
-~ 4
.- 7.4
~.
tli'
Apply SUZUKl SILICONE GREASE to the brake lever bolt.
Apply SUZUKl SILICONE GREASE to the contact point
between piston and brake lever.
, .
( - .,
99000-25100: SUZUKl SILICONE GREASE
i -