CHASSIS
7-19
'
This brake system is filled with an ethylene glycol-based DOT
4
brake fluid. Do not use mlx
different types of fluid, such as silicone-based or petroleum-based.
'
Do not use any brake fluid taken from old, used or unsealed containers. Never reuse brake
fluid left over from the last servicing or which has been stored for a long periods of time.
'
When storing brake fluid, seal the container completely and keep it away from children.
When
replenishing
brake fluid, take care not to get dust into the fluid.
'
When washing brake components, use new brake fluid. Never use cleaning solvent.
A contaminated brake dlsc or brake pad reduces braking performance. Discard contaminated
pads and clean the disc with high quality brake cleaner or neutral detergent.
moq
Handle brake fluid with care: the fluid reacts chemically with paint,
plastics,
rubber materials
etc. and will
damage them severelv.
BRAKE PAD REPLACEMENT
Remove the front wheel and front hub plate.
(W7-10)
Remove the brake caliper mounting bolts
(9
and brake pad
mounting pins
12).
Remove the brake pads.
pad removal.
'
Replace the brake pads as a set, otherwise braking
performance will be adversely affected.
Install the new brake pads.
NOTE:
Before installing the new pads, inspect the pad mounting pins
for wear.
If excessive wear is found, replace them with new
ones.
Apply THREAD
LOCK
SUPER
"1360"
to the brake caliper
mounting
bolts
@I.
a
99000-32130: THREAD
LOCK
SUPER "1360"
Tighten the brake pad mounting pins
(27
and brake caliper
mounting bolts
ti)
to the specified torque.
Brake pad mounting pin: 18
N.m (1.8 kgf-m, 13.0 lb-ft)
Brake caliper mounting bolt:
26
N.m
(2.6
kgf-m, 19.0 lb-ft)
NOTE:
After replacing the brake pads. pump the brake lever several
times to check for proper brake operation and then check the
brake fluid level.
To Next Page
Loading...
