CHASSIS
7-35
BRAKE DISC COVER
Inspect the brake
d~sc cover for damage.
If
any defects are
found, replace the brake disc cover with a new one.
REASSEMBLY AND INSTALLATION
Reassemble and install the front susoension in the reverse order
P
of removal and disassembly. Pay attention to the following
points:
WISHBONE ARM
Press fit the bearing cages with the special tool and
a
suitable
size socket wrench.
@
09924-84521:
Bearlng Installer set
NOTE:
Position the bearings by referring to the illustration of page
7-53.
Apply grease to the needle roller bear~ngs.
99000-25010:
SUZUKl SUPER GREASE
"A"
(or equivalent grease)
Apply grease to the dust seal lips and collars.
99000-25010:
SUZUKl SUPER GREASE "A"
(or equivalent grease)
.--
Install the dust seals and collars into the upper wishbone arm
and lower wishbone arm.
NOTE:
*
Stamped mark on the dust seal must face outside.
Position the dust seals by referring to the illustration of page
7-53.
FRONT SHOCK ABSORBER
Press fit the bearlng cages w~th the special tool and a su~table
slze socket wrench.
09924-84510:
Bearing installer set
NOTE:
Position the bearings
by
referring to the illustration of page
7-53.
I
To Next Page
Loading...
