REASSEMBLY AND INSTALLATION
Reassemble and install the rear shock absorber
in
the reverse
order of removal and disassembly. Pay attention to the following
points:
w
Press fit the bearing cage with the special tool and a suitable
size socket wrench.
09924-84521:
Bearlng installer set
NOTE:
%>
-
-
Position the bearings
by
referring to the illustration
of
page
7-82.
Apply grease to the needle roller bearings.
a
99000-25010: SUZUKl SUPER GREASE
"A"
&
(or equlvalent grease)
.
.
.
fa-
Apply grease to the dust seal lhps and collars
99000-25010:
SUZUKl SUPER GREASE "A"
(or equivalent grease)
-
Install the dust seals
(TJ
and collars
(2)
lnto the rear shock
b
absorber
a/
(>
T~ghten each bolvnut to the spec~f~ed torque
Rear shock absorber nut (Upper)
'31:
60 Nm (6.0 kgf-m, 43.5 lb-ft)
..*
Rear shock absorber
nut
(Lower)
(41:
60 N.m (6.0 kgf-m, 43.5 lb-ft)
Rear cushion rod nut
f51:78 N.m (7.6 kgf-m, 56.5 lb-ft)
To Next Page
Loading...
