Suzuki LT-R450K6 - Master Cylinder Inspection; Master Cylinder Reassembly and Installation

Remove the push rod '77, p~ston assembly 18)
MASTER CYLINDER INSPECTION
MASTER CYLINDER
lnspect the master cylinder bore for any scratches or damage. If
any defects are found, replace the master cylinder with a new
one.
PISTON AND RUBBER PARTS
Inspect the piston surface, primarylsecondary cup and dust boot
for any scratches, wear or damage.
If any defects are found.
replace them with a new one,
MASTER CYLINDER REASSEMBLY AND
INSTALLATION
Reassemble and install the master cylinder in the reverse order
of removal and disassembly. Pay attention to the
followinq point:
Clean the master cylinder components with fresh
brake fluid before reassembly.
'Do not
wipe the brake fluid off after cleanina the
.,
components.
When cleanlng the components, use the specified
brake fluid. Never use different types of fluid or
cleaning solvents such as gasoline, kerosine or oth-
ers.
'Apply brake fluid to the
cyllnder bore and all the
component to be inserted into the bore.
fi Specificatlon and classification: DOT 4