SUSPENSION SETTING
After installing the rear suspension, adjust the spring pre-load
and damping force as follows.
SPRING PRE-LOAD ADJUSTMENT
The set length
222
mm
(8.7
in) provides the maximum spring
0
ore-load.
The set length
236
mm
(9.3
in) provides the minimum spring
pre-load.
STD length:
299
mm
(11.8
in)
LcAUTION_J
-
-
Do not set the spring length out of the specified range.
Remove the rear shock absorber. (W7-68)
Loosen the lock-nut
iT).
Adjust the spring set length by turning the adjuster
h).
Tighten the lock-nut
(71
to the specified toraue.
\
Rear shock absorber lock-nut:
30
N.m
(3.0
kgf-m,
21.5
lb-ft)
Remount the rear shock absorber. (p7-71)
DAMPING FORCE ADJUSTMENT
The rebound and compression damping force are adjustable for
rider's preference, rider's weight and field condition.
NOTE:
Do not turn the adjuster screws more than given position, or the
adjuster may be damaged.
Rebound slde
.
-.
'-A
'1
Fully turn the damping force adjuster
(ij
clockwise. It is at stiffest
position and turn it out to standard setting position.
\
STD position:
7
clicks out from stiffest posltlon
\
-
4,
4
[Fine-tune the adjuster by turning it slightly until two punch
/
marks align.]
.\*
-~
\
-
'_
NOTE:
w
/
Make sure to check the 1st click position by last sound when
turning in the adjuster.
To Next Page
Loading...
