COOLING
AND LUBRICATION
SYSTEM
6-1
l
If
the ECT sensor ohmic value does not change in the propor-
tion indicated, replace
it
with a new one.
Temperature sensor specification
Cooling fan operating temperature:
Standard
(OFF-ON):
Approx.
98
"C (208
"F)
(ON-OFF):
Approx.
93
"C
(199
T)
Temperature
20 "C (68
"F)
50
"C
(122
"F)
80
OC
(1
76
"F)
110 *C (230
OF)
If
the resistance is noted to show infinity or too much different
resistance value, replace the ECT sensor with a new one.
WFON_I
may cause damage if
It
gets a sharp impact.
Do not contact the
ECT
sensor and the column ther-
mometer with a pan.
Standard resistance
Approx. 2.6
kc2
Approx. 0.772 kn
Approx. 0.279 kiL
Approx.
0.1
18
kil
INSTALLATION
Apply engine coolant to the O-ring.
Tighten the ECT sensor to the specified torque
ECT sensor:
12 Nm (1.2
kgf-m,
8.5
lb-ft)
CA~
I--
Take special care when handllng the ECT sensor. It
may cause damage If
it
gets a sharp impact.
Connect the ECT sensor coupler.
Install the fuel tank lower cover and fuel tank.
Check the engine coolant level. (-2-15)
To Next Page
Loading...
