ELECTRICAL
SYSTEM
8-23
INSPECTION
Measure the continuity between the lead wires in the diagram using a tester.
OO@
(i.1
(2
m)
Check that the indicator lights immediately after turning the igni-
tion switch
ON.
If the FllEngine coolant temperature indicator does not light
up,
check the couplers. wires and bulb.
NOTE:
When ignition switch is turned on,
FI
light is lit for
2
seconds and
ECT SENSOR INSPECTION
FllENGlNE COOLANT TEMPERATUER INDICATOR
thereaffer remains unlit
-
Fuel indicator
Neutral indicator
-
FIlEngine coolant tempera-
ture indicator
-
(%
(8)
EN: Ground (Fuel indicator)
---
8116: Ground (Neutral indica-
tor)
0
iDi
BIR: Ground (FIIEngine cool-
ant temperature indicator)
B:
Power source (Indicators)
To Next Page
Loading...
