CHASSIS
7-63
BRAKE DlSC REMOVAL AND INSTALLATION
REMOVAL
Remove the rear wheel.
(D7-10)
Remove the rear axle.
(W7-92)
Remove the brake disc.
INSTALLATION
lnstall the brake disc to the rear axle.
NOTE:
Make
sure
that
the disc is free of
any
greasy matter.
Apply THREAD
LOCK
SUPER
"1360"
to the brake disc bolts
and tighten them to the specified torque.
-99000-32130:
THREAD LOCK SUPER
"1360
C]
Brake disc bolt:
23
N.m
(2.3
kgf-rn,
16.5
lb-tt)
Install the rear axle.
(W7-98)
Install the rear wheel.
(-7-14)
?\\Y
\r
--~
-
BRAKE DlSC INSPECTION
Inspect the brake disc for cracks or damage and measure the
z.-a.
thickness using the micrometer.
If
any defects are found or if the
?'-,-I
?
&
n'
thickness is less than the service limit, replace the brake disc
-
'7'
with a new one.
&
09900-20205:
Micrometer
(0
-
25
mm)
Brake disc thickness
Servlce
Limit:
3.5
mm
(0.138
in)
Remove the brake caliper.
(W7-57)
Measure the runout using the dial gauge.
If
the runout exceeds
the service limit, replace the brake disc with a new one.
09900-20607:
Dial gauge
(11100
mm)
09900-20701:
Magnetic stand
Brake
dlsc runout
Servlce Llmlt:
0.3
mm
(0.012
In)
Install the brake caliper.
(W7-61)
To Next Page
Loading...
