INSTALLATION
Install the handlebars in the reverse order of removal. Pay atten-
tion to the following points:
Apply adhesive agent to the handlebar right and left end and
right and left grip inner wall.
HANDLE
GRIP BOND (commercial available)
Align the punch mark
(A)
on the handlebars with the mating
surface
@of handlebar holder.
First tighten the bolts
(T)
to the specified torque, and then
tighten the bolts
12'1
to the specified torque.
Handlebar clamp bolt:
26
N.m
(2.6
kgf-m,
19.0
lb-ft)
NOTE:
The higher portion of handlebar holder must face forward, so
that the clearance
0
of holder
is
in back of the handlebars.
Apply the grease to the end of starter cable
&
99000-25010: SUZUKl SUPER GREASE "A"
(or equivalent grease)
When remounting the left handle switch. engage the stopper
0
with the handlebar hole
m.
Apply
handle
grip
bond.
Handlebars
Apply
handle
gnp
bond.
r
-
Q
,"
7
8
.--------A&
/r-P
.'
(1.'
'--
-q=.
i->\
.
.
.
\,
:
n,
:.I
-
\:L
P'
.
*.
/-'!-q
-
Ad-
To Next Page
Loading...
