Suzuki LT-R450K6 - Installation; Inspection

COOLING AND LUBRICATION SYSTEM 6-9
INSTALLATION . ** *- -
Install the cooling fan unit in the reverse order of removal. Pay
-
-
attention to the following points:
9
Apply a small quantity of the THREAD LOCK SUPER "1303"
-
c.
on the cooling fan motor shaft.
Tighten the cooling fan nut.
a 99000-32030: THREAD LOCK SUPER "1303"
8 -
d
INSPECTION
Remove the front fender. (-7-6)
v,
Disconnect the cooling fan coupler (0.
Test the cooling fan motor for load current with an ammeter
connected as shown in
the illustration.
i
The voltmeter is for making sure that the battery (2) applies 12
volts to the cooling fan motor (3. With the cooling fan motor
with electric motor fan running at full speed, the ammeter
iS)
should be indicating not 5 amperes and more.
If the fan motor does not turn, replace the motor assembly
with a new one.
NOTE:
When making above test, it is not necessary to remove the cool-
ing fan unit,