7-20
CHASSIS
BRAKE FLUID REPLACEMENT
w
vm
. Place the vehicle on a level surface and keep the handlebar
straight.
-
I.
Remove the master cylinder reservoir cap and diaphragm.
Suck
UD
the old brake fluid as much as ~0sSible.
Fill the reservoir with new brake fluid.
6
Specification and classlfication:
DOT
4
-
Connect a clear hose to the alr bleeder valve and insert the
Yb-1
!
other end of the hose into a receptacle.
Loosen the air bleeder valve and pump the brake lever until
.f--
I
..
the old brake fluid is completely out of the brake system.
---
--
Close the air bleeder valve and disconnect the clear hose. Fill
"--ah
the reservoir with new brake fluid to the upper mark of the res-
P,
-, ,
.c'
ewoir.
2
T
I
p
.
,
.
&~.ia
g
m
Brake air bleeder valve: 6 N.m (0.6 kgf-m, 4.5 lb-ft)
\~~-
v".
"b
..'
1
BRAKE CALIPER REMOVAL AND
DISASSEMBLY
Remove the front wheel and front hub plate.
(W7-10)
-
Disconnect the brake hose from the brake caliper by remov-
ing the brake hose union bolt
(7)
and allow the brake fluid to
-7
.,
drain into a suitable receptacle.
!
~-
Ti\
Remove the brake caliper by removing the brake caliper
;.
I
mounting bolts
i21.
2.4
Remove the brake pads.
(W7-19)
iJ-
LCPUTloN
Brake fluid, if
it
leaks,
will
interfere with safe running
and discolor painted surfaces. Check the brake hose,
brake pipe and hose joints tor cracks and leakage of
brake fluid.
'
Never reuse the brake fluid left over from previous
servicing and
whlch has been stored for long peri-
ods of time.
Bleed air from the brake system.
(cz72-21)
'1
.~
.
.'
..
,
'r
To Next Page
Loading...
