7-80
CHASSIS
REASSEMBLY AND INSTALLATION
Reassemble and install the cushion rod and cushion lever in the
reverse order of removal and disassembly. Pay attention to the
following points:
Press fit the bearing cages with the special tool and a suitable
size socket wrench.
09924-84521:
Bearing installer set
NOTE:
Position the bearings
by
referring to the illustration of page
7-82.
Apply grease to the dust seal lips, spacers, collars and needle
roller bearings.
99000-25010:
SUZUKl
SUPER
GREASE
"A"
_-
(or equivalent grease)
.
fl
5
NOTE:
The stamped mark on the dust seals must face outside.
To Next Page
Loading...
