Suzuki LT-R450K6 - Using the Multi-Circuit Tester

USING THE MULTI-CIRCUIT TESTER
Properly use the multi-circuit tester +I and 1-J probes.
Improper use can cause damage to the motorcycle and
tester.
If the voltage and current values are not known, begin mea-
suring
in the highest range.
- When measuring the resistance, make sure that no voltage is
applied.
If voltage is applied, the tester will be damaged.
After using the tester, be sure to turn the switch to the OFF
position.
09900-25008: Multi-circuit tester set
CAUTION]
I I- -
Before using the multi-circuit tester, read its instruc-
tion manual.
NOTE:
* When connecting the multi-circuit tester, use the needle
pointed probe to the back
s~de of the lead wlre coupler and I
connect the probes of tester to them.
Use the needle pointed probe to prevent the rubber of the
water proof coupler from damage.
09900-25009: Needle pointed probe set