7.56
CHASSIS
Apply THREAD LOCK
SUPER"1360
to the callper mountlng
bolts
'
1
a
99000-32130: THREAD LOCK
SUPER
"1360
(
Tighten the caliper mounting bolts to the specified torque.
rn
Brake caliper rnountlng bolt:
26
N.m
(2.6
kgf-rn,
19.0
lb-ft)
-4mpqIlJ-
-
Tighten the pad mounting pins
15)
to the specified torque, and
then bend the lock washer.
!,
rn
Pad mounting pin:
18
N.m
(1.8
kgf-m,
13.0
lb-ft)
'I
NOTE:
After replacing the brake pads, pump the brake pedal several
b
times to check for proper brake operation and then check the
brake fluid level.
Adjust the parking brake.
(D2-19)
BRAKE
FLUID
REPLACEMENT
'1
Place the vehicle on a level surface.
Remove the seat.
(W7-6)
~\,
Remove the master cylinder reservoir cap and diaphragm.
Suck up the old brake fluid as much as possible.
Y
4
i..
,#
Fill the reservoir with new brake fluid.
Specification and classlflcation:
DOT
4
-
A
1PJ
b
;
'1
-4
Connect a clear hose to the air bleeder valve and insert the
.-T-m
&?
,
-
L
other end
of
the hose into a receptacle.
t
Loosen the air bleeder valve and pump the brake pedal until
I
?
the old brake fluid is completely out of the brake system.
Close the air bleeder valve and disconnect the clear hose. Fill
the reservoir with new brake fluid to the upper level.
rn
Brake air bleeder valve:
6
N.m
(0.6
kgf-m,
4.5
lb-ft)
e4
.~
p5mizxl
'
Never reuse the brake fluid left over from previous
I
,
,
"
I
servicing and which has been stored for long peri-
I.:.
f'.~
'-
'';
&L
ods of time.
Bleed air from the brake system.
(c3-2-21)
To Next Page
Loading...
