7-104
CHASSIS
Place the drive chain link being disjointed on the holder part
c81
of the tool.
Turn in both the adjuster bolt
(6'1
and pressure bolt
"A
(31
so
that each of their end hole fits over the chain joint pin properly.
Tighten the pressure bolt
"A
(3)
with the bar.
Turn in the pressure bolt
"B"
141
with the bar
iS)
and force out
the drive chain joint pin
(0.
lCAUTlON
Continue turning
in
the pressure bolt
"8"
141
until the
joint pin has been completely pushed out of the chain.
NOTE:
After the joint pin
Wi
is removed, loosen the pressure bolt
"B'r4)
and then pressure bolt
'flAY31.
Remove the joint pin
(3)
of the other side of joint plate.
Never reuse
Joint pins, O-rings and plates. After joint
pins,
0-rlngs and plates have been removed from the
drive chain, the removed joint pins, O-rings and plates
should be discarded and new
ioint plate, O-rings and
plate must be installed.
DRIVE
CHAIN CONNECTING
JOINT PLATE INSTALLATION
-
Set up the special tool as shown in the illustration.
11
1
Tool body
6)
Adjuster bolt
i2!
Grip handle (without hole)
13)
Joint plate holder
6)
Pressure bolt
"A"
(engraved mark "C520)
(77
Bar
($1
Wedge holder
&
wedge pin
Connect both ends of the drive chain with the joint pin
@I
inserted from the inside
iR
as installed on the motorcycle.
(9)
O-ring
...
4 pcs.
rlD
Joint plate
Joint set part number
RK:
27620-43820
Do not use jolnt cllp type
of
drive chain. The joint clip
may have a chance to drop
whlch may cause severe
damage to motorcycle and severe injury.
To Next Page
Loading...
