Apply grease on the recessed portion of the joint plate holder
131
and set the joint plate
ibl.
NOTE:
When positioning the joint plate
IW
on the tool, its stamp mark
must face the joint plate
holder
in
side.
Set the drive chain on the tool as illustrated and turn in the
adjuster bolt
15)
to secure the wedge holder
&
wedge pin
($1.
Turn in the pressure bolt
"A"
(61
and align two joint pins
(I!)
properly with the respective holes of the joint plate
Turn in the pressure bolt
"A
!GI
further using the bar
C;i)
to
press the joint plate over the
joint pins.
Continue pressing the joint plate until the distance between
the two joint plates come to the specification.
Joint plate distance specification
(WI
of the joint plate be made excessively
beyond the specified dimension, the work should be
redone
using the new joint parts.
JOINT
PIN STAKING
Set up the special tool as shown in the illustration.
'1
1
Tool body
(21
Grip handle
i3>
Pressure bolt
"A
Adjuster bolt (without hole)
(5,
Staking pin (stowed inside grip handle behind rubber cap)
(6)
Bar
NOTE:
Before staking the joint pin, apply
a
small quantity of grease to
the staking
p~n
(9.
To Next Page
Loading...
