7106
CHASSIS
Stake the jolnt pln by turning
(approximately
718
turn) the
pressure bolt
"A
(3
wlth the bar until the pin end diameter
becomes the
specifled dimenslon.
Pin end diameter specification
ID\
Adiust the drive chain, after connectina it.
(D2-26)
1
I
'
After joining of the chain has been completed, check
to make sure that the link is smooth and no abnormal
condition is found.
'
Should any abnormal condition be found, reassem-
ble the chain link using the new joint parts.
1
I
To Next Page
Loading...
