Align the punch mark
IF)
on the handlebars with the mating
surface
iG
of clutch lever holder.
Tighten the clutch lever holder clamp bolts to the specified
torque.
Clutch lever holder clamp bolt:
10
N.m
(1.0
kgf-rn,
7.5
lb-ft)
HI
Clearance
Align the punch mark
on the handlebars with the mating
surface
IJ)
of throttle lever case.
Tighten the throttle lever case bolts to the specified torque.
rn
Throttle lever case bolt:
5
N.rn
(0.5
kgf-rn,
3.5
lb-ft)
Install the brake master cylinder.
(W7-28)
To Next Page
Loading...
