Apply THREAD LOCK SUPER
"1303
to the caliper holder
slide pin
(11.
a99000-32030:
THREAD LOCK SUPER
"1303"
Install the caliper holder slide pin
a),
washer
i2)
and caliper
holder
(3,
to the caliper.
Tighten the caliper holder slide pin
flli
to the specified torque.
[T1
Caliper holder slide pin:
23
N.m
(2.3
kgf-m,
16.5
lb-ft)
Install the pad spring and pads.
(W7-55)
NOTE:
When installing !he caliper holder slide pin
(Ir)
and washer
12).
the
convex of washer must face slide pin as shown in illustration.
Apply THREAD LOCK SUPER
"1360
to the caliper mounting
""1'
!
bolts and tighten the them to the specified torque.
-J7"m!
I"
. .
'-
-
-
a
99000-32130:
THREAD LOCK SUPER
"1360"
1
4
Brake caliper mounting bolt:
26
N.m
(2.6
kgf-m.
19.0
lb-ft)
t-.?%-
NOTE:
Before remounting the brake caliper, push the brake caliper pis-
w,
)?
-
ton all the
way
into the caliper.
I
Tighten the brake hose union bolt.
Install the parking brake housing
GR
and new gasket.
p!-'?y"-A
a,
'%
!
Apply THREAD LOCK SUPER
"1360"
to the parking brake
-.
1
.,.
bolts and tighten them to the specified torque.
,
.
I
-99000-32130:
THREAD LOCK SUPER
"1360"
1
*
-~
m
Brake hose union
bolt:
23
N.m
(2.3
kg4-m,
16.5
lb-ft)
Parking brake housing bolt:
28
N.m
(2.8
kgf-m,
20.0
lb-ft)
7
FUTION]
'The removed brake hose washers should be
replaced with new ones
In order to prevent leakage
of brake
fluld.
Bleed air from the system after reassembling the
brake caliper.
(-2-21)
--
-.-
When repiaclng the boot w~th a new one, apply SUZUKl SILI-
CONE GREASE to the groove of
parklng brake axle.
99000-25100:
SUZUKl SILICONE GREASE
To Next Page
Loading...
