CHASSIS
7-39
Loosen the lock-nut
rl)
with the special tool.
Adjust the spring set length by turning the adjuster
12).
Tighten the lock-nut
(r!
to the specified torque.
(T1
Front shock absorber lock-nut:
30
N.m
(3.0
kgf-m,
21.5
lb-ft)
09910-60611:
Universal clamp wrench
DAMPING FORCE ADJUSTMENT
The rebound and compression damping force are adjustable for
rider's preference, rider's weight and field condition.
NOTE:
Do not turn the adjuster screws more than given position, or the
adjuster may be damaged.
Rebound side
Fully
turn the damping force adjuster
(0
clockwise. It is at stiffest
pos~tion and turn it out to standard setting position.
STD position:
1
and
112
turns out from stiffest position
[Fine-tune the adjuster by turning it slightly until two punch
marks align.]
Compresslon side
Fully turn the damping force adjuster
ti)
clockwise. It is at stiffest
position and turn it out to standard setting position.
STD posltlon:
2
and
114
turns out from stiffest position
[Fine-tune the adjuster by turning it slightly until two punch
marks align.]
Standard suspension setting
Standard
FRONT
Spring set length
274.5
mrn
(10.81
in)
Damping force adjuster
Rebound
1
and
112
turns out from stiffest
position
Compression
2
and
114
turns out from stiffest
position
To Next Page
Loading...
