Suzuki LT-R450K6 - Page 286

7.50 CHASSIS
Tighten the steering shaft holder bolts to the specified torque.
-k?T
Steering shaft holder bolt: 23 N.m (2.3 kgf-m, 16.5 lb-ft)
NOTE: I .., :
v'
Make sure that the wiring harness, cables and brake hose rout-
..
- 't
ing are properly. (C39-15, 78 and 22)
(.-j
Apply grease to the dust seal.
Install the dust seal to the steering shaft
When installing the steering arm plate, align the wide spline
iC) of steering shaft with slit (Dl of steering arm plate.
* Apply THREAD LOCK SUPER "1322" to the thread part of
steering shaft.
-99000-32110: THREAD LOCK SUPER "1322"
(or equivalent thread lock)
Tighten the steering shaft nut iii to the specified torque.
rn Steering shaft nut: 120 N.m (12.0 kgf-m, 87.0 lb-ft)
Apply THREAD LOCK SUPER "1322" to the thread part of
steering arm plate boil
(2) and tighten it to the specified
torque.
a99000-32110: THREAD LOCK SUPER "1322"
(or equivalent thread lock)
rn Steering arm plate bolt: 29 N.m (2.9 kgf-m, 21.0 lb-R)
Install the cotter pin.
I
Replace the removed cotter pin wlth a new one.
I