+
If parts replacement is necessary, replace the parts with Suzuki Genulne Parts or their equiva-
lent.
When removlng parts that are to be reused, keep them arranged in an orderly manner so that
they may be reinstalled in the proper order and orientatlon.
*
Be sure to use special tools when instructed.
Make sure that all parts used in reassembly are clean. Lubricate them when specifled.
Use the specified lubricant. bond, or sealant.
*
When removing the battery, dlsconnect the negative cable first and then the positive cable.
*
When reconnecting the battery, connect the positive cable first and then the negative cable,
and replace the terminal cover on the positive terminal.
When performing service to electrical parts, if the service procedures do not require use of
battery power, disconnect the negative cable from the battery.
When tightening the cylinder head or case bolts and nuts, tlghten the larger sizes first.
Always tighten the bolts and nuts diagonally from the inside toward outside and to the speci-
fied tightening torque.
Whenever you remove oil seals, gaskets, packing, O-rings, locking washers, self-locking
nuts, cotter pins, circlips and certain other parts as specified, be sure to replace them with
new ones. Also, before installing these new parts, be sure to remove any left over material
from the mating surfaces.
Never reuse a circlip. When installing a new circllp, take care not to expand the end gap larger
than required to slip the
clrclip over the shaft. After Installing a circlip, always ensure that it is
completely seated
in
its groove and securely fltted.
'
Use a torque wrench to tighten fasteners to the
specified
torque. Wipe off grease and oil if a
thread is smeared
with them.
1
After reassembling, check parts for tightness and proper operation.
'
To protect the environment, do not unlawful\y dispose of used motor oil, engine coolant and
other fluids: batteries and
tlres.
'
To protect Earth's natural resources, properly dispose of used vehicle and parts.
To Next Page
Loading...
