Remove the bearings (outer) with special tools.
a
09921-20240:
Bearing remover set
1.
The removed bearings must be replaced wlth new
ones.
Remove the dust seals (inner).
-
Remove the bearings (inner) with special tool.
a
09913-70210:
Bearing installer set
The removed bearings must be replaced with new
ones.
SWINGARM PIVOT SHAFT
Using a dial gauge, check the pivot shaft
runout. If the runout
exceeds service limit, replace the pivot shaft with a new one.
a
09900-20607:
Dial gauge
(11100
mm,
10
mm)
09900-20701:
Magnetic stand
09900-21304:
V-block
(100
rnm)
Swingarm pivot shaft runout:
Service Limit:
0.3
rnm
(0.01
in)
SWINGARM
lnspect the swingarm for cracks and damage.
If
any defects are
found, replace the
swingarm with a new one.
CHAIN BUFFER
Inspect the
cha~n buffer for wear and damage.
If
any defects are
found, replace the chain buffer
w~th
a
new one.
To Next Page
Loading...
