8-16
ELECTRICAL
SYSTEM
Apply
12
V
to
I.%
and
@!
terminals and check for continuity
between the positive and negative terminals using the
multi-circuit tester. If the starter relay clicks and continuity is
C'"1
-.
(a,
found, the relay is ok.
\.
09900-25008: Multi-circuit tester set
:;w
Tester knob indicatlon: Continuity test
(-11))
,.>
--
-?!,',
[CAUTION
1
fi
\
Do not apply battery voltage to the starter relay for
more than five seconds,
slnce the relay coil may over-
heat and get damaged.
Measure the relay coil resistance between the terminals using
the multi-circuit tester. If the resistance is not within the speci-
fied value, replace the starter relay with a new one.
a
09900-25008: Multi-circuit tester set
Starter relay resistance:
3
-
6
Q
To Next Page
Loading...
