PERIODIC MAINTENANCE
2-25
TOE
Place the vehicle on level ground.
Make sure the tire pressure for right and left tires is the same
and set to the proper specification.
Set the front wheels in the straight position.
Place a load of
75
kg
(165
lbs) on the seat.
Measure the distance
(&
and
i@
of the front wheels with a
toe-in gauge as shown and calculate the difference between
(A)
and
(Ri.
id:,
-
(A1
=
Toe-in
Toe-in:
0
+
4
mm
(0
*
0.16
in)
If the toe-in is out of specification, bring it into the specified
range.
(D7-52)
DRIVE
CHAIN
Clean, lubricate and Inspect each time the vehicle is
ridden.
Visually check the drive chain for the possible defects listed
below. (Support the vehicle by a jack and a wooden block, turn
the rear wheel slowly by hand with the transmission shifted to
Neutral.)
'
Loose pins
'
Excessive wear
Damaged rollers
Improper chain adjustment
+
Dry or rusted links
"
Missing O-ring seals
Kinked or binding links
If any defects are found, the drive chain must be replaced.
NOTE:
When replacing
the
drive chain, replace the drive chain and
sprockets as a set.
CHECKING
Place the vehicle on
a
level ground.
Loosen the rear axle housing set nuts.
Forward
1-
8-
To Next Page
Loading...
