3-50 ENGINE
CAM ROCKER ARM
• Assemble the cam rocker arms 1, shaft 2 and washer 3.
NOTE:
Align the hollows A of the cam rocker arm.
• Apply engine oil to the cam rocker arm shaft 4.
• Install the cam rocker arms 5, spring 6 and washer 7 to the
upper crankcase/cylinder.
• Keep the rocker arms 5 open.
CAMSHAFT ASSEMBLY
• Install the camshaft assembly 1 and washer 2.
• Align the hole A of the camshaft 1 with the matching mark B
on the cam drive gear 3.
NOTE:
Piston must be at TDC before installing the cam assembly.
• Apply SUZUKI BOND “1215” to the part shown in the photo-
graph.
99000-31110: SUZUKI BOND “1215” or equivalent
NOTE:
Make surfaces free from moisture, oil, dust and other foreign
materials.
GENERATOR CASE
• Install the dowel pins 1 and gasket 2.
* Apply engine oil to the gears.
* The removed gasket must be replaced with a new
one.
PartShark.com
877-999-5686
To Next Page
Loading...
