ENGINE 3-51
• Tighten the generator case bolts to the specified torque.
Generator case bolt: 11 N·m (1.1 kgf-m, 8.0 lb-ft)
CVT CASE
• Install the dowel pins 1 and gasket 2.
• Tighten the CVT case bolts to the specified torque.
CVT case bolt: 11 N·m (1.1 kgf-m, 8.0 lb-ft)
MOVABLE DRIVEN FACE
• Install the drive belt 1 to the movable driven face 2.
NOTE:
With the clutch shoe spring compressed by hands, install the
drive belt 1 between the movable driven face 2 and fixed
driven face.
The removed gasket must be replaced with a new one.
* Degrease the drive belt contact surface (pulley face).
* Position the drive belt so that the arrow A points the
engine rotating direction.
PartShark.com
877-999-5686
To Next Page
Loading...
