Suzuki LT-Z50 - Preparation for Cleaning

3-52 ENGINE
• Tighten the clutch housing nut 3 to the specified torque with
the special tool.
 09930-40113: Rotor holder
 Clutch housing nut: 50 N·m (5.0 kgf-m, 36.0 lb-ft)
NOTE:
Degrease the inside of the clutch housing and clutch shoe.
MOVABLE DRIVE FACE
• Install the washer 1.
• Install the movable drive face assembly 2 and fixed drive
face 3.
NOTE:
Degrease the drive belt contact surfaces.
• Install the starter cup assembly 4, wave washer and fixed
drive face nut 5.
NOTE:
The concave side of the washer must face the starter cup 4.
• Tighten the fixed drive face nut 5 to the specified torque with
the special tool.
 09930-40113: Rotor holder
 Fixed drive face nut:
Initial: 13 N·m (1.3 kgf-m, 9.5 lb-ft)
Final: 50 N·m (5.0 kgf-m, 36.0 lb-ft)
PartShark.com
877-999-5686