3-54 ENGINE
• Tighten the generator rotor nut 4 to the specified torque with
the special tool.
09930-40113: Rotor holder
Generator rotor nut: 35 N·m (3.5 kgf-m, 25.5 lb-ft)
STARTER MOTOR
• Install the starter motor 1.
CYLINDER HEAD
• Apply MOLYBDENUM OIL SOLUTION to both ends of the
push rods 1.
MOLYBDENUM OIL SOLUTION
• Install the push rods 1 to the cam rocker arm hollows A.
• Turn the crankshaft counterclockwise and align the line B on
the generator rotor with the index mark C of the generator
case.
Be careful not to damage the generator coil by the
special tool.
Hole
Match mark
PartShark.com
877-999-5686
To Next Page
Loading...
