Screen that enables setting the reverberation time
measurement parameters: Start Delay, Method,
Recording Time, Time Step, Averaging, Noise
Mar., Octave, Freq. Range, Logger Name and
Level.
Delay between pressing the <Start> key and the
start of the RT60 measurement.
Method of the RT60 calculation: Decay
(Interrupted Noise Method) or Impulse (Impulse
Response Method). The selection of the method
depends on the used type of the sound source.
Time of measurement data (sound pressure level
decay curve) registration during RT60
calculations: 1s .. 30 s or Auto.
Time-step of data registration (sound pressure
level) in the file during RT60 calculations: 2, 5, 10,
20, 50 ms.
Averaging of the reverberation time results from
several measurements during RT60 calculations.
Margin value to the calculated noise level for RT60
calculations: 0 ÷ 20 dB.
Type of spectrum (1/1-octave or 1/3-octave)
based on which the RT60 analysis is performed.
To Next Page
Loading...
