Svantek SV 973 User Manual

SVAN 973 User Manual
31
4 CONFIGURING MEASUREMENT PARAMETERS – Measurement
The Measurement section combines elements related to
measurement parameters configuration.
To open the Measurement section, press the <Menu>
key, select the Measurement position and press
<Enter>.
<ENT>
The content of the Measurement list depends on the
Interface mode (Simple and Advanced) and
Measurement Function. Some example screens for
Advanced and Simple modes are presented.
The Measurement section contains following positions:
General Set allowing you to set general measurement parameters;
Meas. Trig. allowing you to configure the measurement trigger. This position appears only in the
Advanced interface mode;
Profiles allowing you to set parameters specific for the profile. This position disappears in the
Dosimeter function;
Profile 1 (2,3) allowing you to set parameters specific for profiles in the Dosimeter function. These
positions appear only in the Dosimeter function instead of Profiles;
Alarm allowing you to programme the alarm function. This position appears only in the
Dosimeter function and Advanced interface mode;
Logging allowing you to configure the logging function;
Spectrum allowing you to set spectrum parameters. This position becomes available only in
1/1 Oct. and 1/3 Oct. functions;
Range allowing you to check the available measurement range;
Comp. Filter allowing you to switch on the required compensation filter. This position appears only
in the Advanced interface mode;
Stat. Lev. allowing you to define 10 statistical levels;
Exp. Time allowing you to set the exposure time for dose measurements. This position appears
only in the Dosimeter function and Advanced interface mode;
Timer allowing you to programme the internal timer. This position appears only in the
Advanced interface mode.
4.1 SETTING GENERAL MEASUREMENT PARAMETERS – GENERAL SETTINGS
The General Set screen allows to programme general
measurement parameters: delay of the measurement
start of (Start Delay), synchronisation with the
instrument’s RTC (Start Sync.), integration
period/measurement run time (Integr. Per), repetition of
measurement cycles (Rep. Cycles), duration of day
periods (Day Time L.) and LEQ detector type
(LEQ Integr.).
<ENT>

Svantek SV 973 Specifications

General

Brand	Svantek
Model	SV 973
Category	Measuring Instruments
Language	English