Symmetricom TimeProvider 1000 User Manual

Chapter 6 Maintaining and Troubleshooting the TimeProvider
Troubleshooting the TimeProvider
174 TimeProvider User’s Guide 097-58001-02 Revision C – August 2005
<aid> = INP1 or INP2
INPDISQ The specified input was
Disqualified or Qualified
as a possible system
reference. The fault
condition must be
continuously present for
the Fault Delay Time
(FLTDELAY) before
disqualifying the input
as a possible reference.
After INPDISQ is set,
the alarm clears when
the input signal is fault
free for the Clear Delay
Time (CLRDELAY).
T1 NSA FLT
DLY
YES MN MN MN
INPAIS The specified input port
is receiving an Alarm
Indication Signal. When
AIS is detected, the
input is immediately
removed from the
possible reference list.
The AIS must be
continuously present for
the Fault Delay Time
(FLTDELAY) before
disqualifying the input
as a possible reference.
After INPAIS is set, the
alarm clears when the
input signal is AIS free
for the Clear Delay Time
(CLRDELAY).
T1 NSA IMMEDNO MNMNMN
Table 6-7. Alarms (Continued)
Alarm ID
Or
CONDTYPE
Alarm Condition
Description
AID
TYPE
Service
Affecting
Error
Delay
Default
Error
Delay
Editable
Alarm Default
Level
SSU PRS SUB

Symmetricom TimeProvider 1000 Specifications

General

Brand	Symmetricom
Model	TimeProvider 1000
Category	Clock
Language	English