BLUETOOTH
®
HANDS-FREE HEADSET OR CAR KIT To use a Bluetooth
stereo/mono hands-free headset or car kit, do the following:
1 Press
JUMP to go to the Jump screen. Press MENU to open the menu,
then select Bluetooth to open the submenu. Make sure Bluetooth
features are “on”.
2
While you are in your car, make sure your hands-free headset or car kit
is ready to pair by following the manufacturer’s instructions. On your
device, go into the Phone application. Press MENU and select Settings >
Pairing.
3 From the Pairing dialog box, select your Bluetooth hands-free headset
or car kit from the list of devices (it may take a few seconds for the list to
populate). If prompted, type the device’s PIN code, then press DONE
to dismiss the PIN Code dialog box.
4
By default, your call’s sound will go through the device handset. To
send or receive your call using a Bluetooth device, press MENU and
select Transfer Sound to, then select your Bluetooth device from the
submenu.
You may transfer the call’s sound either before or during a call.
5
Place your call.
6
When finished with your call, press END CALL .
STEREO HEADSET JACK
Always connect your headset to your device
before making/receiving a call.
To use the headset button:
n Press the button once to answer a call and again to end it.
n During a call, press once to answer a second incoming call and put the
first caller on hold.
n
With two callers on the phone, press the button once to end the active call
and press again to resume the on-hold call.
12 Device Basics
To Next Page
Loading...
