User Guide Options and accessories
Vertical position after oversized barcode (BarTop)
This paramater controls the vertical position of characters with standard height
which follow oversized characters.
This function is only effective in Genicom ANSI emulation.
Press BarTop (2) key.
Use the < (2) or > (3) key to select the desired setting.
Setting Options: Off/On
Default Setting: Off
If this option is disabled (Off), then the printer advances paper 1/8 inch when
exiting oversized characters. This characteristic is retained for compatibility with
older products.
If the option is enabled (On), then the current vertical position following the
printing of an oversized character will be the top of the oversized character cell. If
the next object on the page is located below this point, then the printer uses
vertical logic seeking to economize on paper movement.
Confirm the setting by pressing the Set key (1).
Vertical position after oversized character (LCPtop)
This paramater controls the vertical position of characters with standard height
which follow oversized characters.
This function is only effective in Genicom ANSI emulation.
Press LCPtop (3) key.
Use the < (2) or > (3) key to select the desired setting.
Setting Options: Off/On
Default Setting: Off
83
To Next Page
Loading...
