Options and accessories User Guide
If this option is disabled (Off), then the printer advances paper 1/8 inch when
exiting oversized characters. This characteristic is retained for compatibility with
older products.
If the option is enabled (On), then the current vertical position following the
printing of an oversized character will be the top of the oversized character cell. If
the next object on the page is located below this point, then the printer uses
vertical logic seeking to economize on paper movement.
Confirm the setting by pressing the Set key (1). Press the Next key (4) to access
the next group of parameters.
Form feed mode (Ffmode)
Specifies whether a form feed is to be performed when the paper reaches the top
print line.
Press FFmode (2) key.
Use the < (2) or > (3) key to select the desired setting.
Setting Options: On/Off
Default Setting: Off
FFmode = On: If the paper is positioned in the first printing
line (TOF), form feeds will be ignored.
FFmode = Off: Form feed will be performed in all cases.
Confirm the setting by pressing the Set key (1).
Setting and activating options (PapOpt)
For setting the optional automatic sheet feeders (ASFs) and optional tractors; see
Paperway. Also regulates the activation of ASFs and/or optional tractors.
Press PapOpt (3) key.
84
To Next Page
Loading...
