2
83507013 Rev G
2.12 Supplemental Characteristics ________________________________________________ 32
2.13 Genesys ™ Outline Drawings _______________________________________________ 33
3 INSTALLATION ____________________________________________________________ 34
3.1 General ______________________________________________________________ 34
3.2 Preparation for Use ________________________________________________________ 34
3.3 Initial Inspections __________________________________________________________ 34
3.4 Rack Mounting ____________________________________________________________ 35
3.4.1 To install the Power Supply in a Rack: __________________________________ 35
3.4.2 Rack Mount Slides (optional): _________________________________________ 35
3.5 Location, Mounting and Cooling _______________________________________________ 35
3.6 AC Source Requirements ___________________________________________________ 35
3.7 AC Input Power Connection __________________________________________________ 36
3.7.1 AC Input Connector, 1500W Models ____________________________________ 36
3.7.2 AC Input Connector, 750W Models _____________________________________ 36
3.7.3 AC Input Cord _____________________________________________________ 36
3.7.4 AC Input Wire Connection, 1500W Models _______________________________ 37
3.8 Turn-On Checkout Procedure ________________________________________________ 37
3.8.1 General __________________________________________________________ 37
3.8.2 Prior to Operation __________________________________________________ 38
3.8.3 Constant Voltage Check _____________________________________________ 38
3.8.4 Constant Current Check _____________________________________________ 38
3.8.5 OVP Check _______________________________________________________ 38
3.8.6 UVL Check _______________________________________________________ 39
3.8.7 Foldback Check ___________________________________________________ 39
3.8.8 Address Setting ____________________________________________________ 39
3.8.9 Baud Rate Setting (RS232 and RS485 only) _____________________________ 39
3.9 Connecting the Load _______________________________________________________ 40
3.9.1 Load Wiring _______________________________________________________ 40
3.9.2 Current Carrying Capacity ____________________________________________ 40
3.9.3 Wire Termination ___________________________________________________ 41
3.9.4 Noise and Impedance Effects _________________________________________ 41
3.9.5 Inductive Loads ____________________________________________________ 41
3.9.6 Making the Load Connections _________________________________________ 42
3.9.7 Connecting Single Loads, Local Sensing (default). _________________________ 44
3.9.8 Connecting Single Loads, Remote Sensing ______________________________ 45
3.9.9 Connecting Multiple Loads, Radial Distribution Method _____________________ 45
3.9.10 Multiple Load Connection with Distribution Terminals ______________________ 46
3.9.11 Grounding Outputs ________________________________________________ 46
3.10 Local and Remote Sensing _________________________________________________ 46
3.10.1 Sense wiring _____________________________________________________ 46
3.10.2 Local sensing ____________________________________________________ 47
To Next Page
Loading...
