3
83507013 Rev G
3.10.3 Remote sensing __________________________________________________ 47
3.10.4 J2 sense connector technical information _______________________________ 48
3.11 Repackaging for Shipment __________________________________________________ 48
4 FRONT AND REAR PANEL CONTROLS AND CONNECTORS _______________________ 49
4.1 Introduction ______________________________________________________________ 49
4.2 Front Panel Controls and Indicators ____________________________________________ 49
4.3 Rear Panel Connections and Controls __________________________________________ 51
4.4 Rear Panel SW1 Setup Switch ________________________________________________ 52
4.4.1 SW1 Position Function ______________________________________________ 53
4.4.2 Resetting the SW1 Switch ____________________________________________ 53
4.5 Rear Panel J1 Programming and Monitoring Connector ____________________________ 53
4.5.1 Making J1 connections ______________________________________________ 54
5 LOCAL OPERATION ________________________________________________________ 56
5.1 Introduction ______________________________________________________________ 56
5.2 Standard Operation ________________________________________________________ 56
5.2.1 Constant Voltage Mode ______________________________________________ 56
5.2.2 Constant Current Mode ______________________________________________ 57
5.2.3 Automatic Crossover ________________________________________________ 57
5.3 Over Voltage Protection (OVP) _______________________________________________ 57
5.3.1 Setting the OVP Level _______________________________________________ 57
5.3.2 Activated OVP protection indications ___________________________________ 58
5.3.3 Resetting the OVP circuit ____________________________________________ 58
5.4 Under Voltage Limit (UVL) ___________________________________________________ 58
5.4.1 Setting the UVL Level _______________________________________________ 58
5.5 Foldback Protection ________________________________________________________ 58
5.5.1 Setting the Foldback Protection ________________________________________ 58
5.5.2 Resetting Activated Foldback Protection _________________________________ 58
5.6 Output ON/OFF Control _____________________________________________________ 59
5.7 Output Shut-Off (SO) Control via Rear Panel J1 Connector _________________________ 59
5.8 Enable/Disable Control via Rear Panel J1 Connector ______________________________ 60
5.9 CV/CC Signal _____________________________________________________________ 60
5.10 PS_OK Signal ___________________________________________________________ 60
5.11 Safe-Start and Auto-Restart Modes ___________________________________________ 61
5.11.1 Auto-Restart Mode ________________________________________________ 61
5.11.2 Safe-Start Mode __________________________________________________ 61
5.12 Over Temperature Protection (OTP) __________________________________________ 61
5.13 Last Setting Memory ______________________________________________________ 61
5.14 Series Operation _________________________________________________________ 62
5.14.1 Series Connection for Increased Output Voltage _________________________ 62
5.14.2 Series Connection for Positive and Negative Output Voltage ________________ 63
5.15 Parallel Operation ________________________________________________________ 64
To Next Page
Loading...
