56 44 1670 001-GB-I
HDA eco
5.3.4.3.10.5 Send delay (LAN)
Display (e.g.):
This menu item is only available for operation with mytecalemit Cloud.
This is where users can define the time delay after which a completed dispensation is
transmitted to the web server. A higher value can e.g. enable the operator to perform
several refueling procedures in succession before subsequently transferring them in
batch to save time. A value between 0 seconds (transmission directly upon comple-
tion of refueling procedure) and 255 seconds can be entered. The factory default is
20 seconds.
5.3.4.3.10.6 Automatic connection time (LAN)
Display (e.g.):
This menu item is only available for operation with mytecalemit Cloud.
This allows a fixed time to be specified at which the HDA eco connects to the web
server once a day to synchronize any changes in the master data. This time serves as
the start time for the connection interval set (see 5.3.4.3.12.8). With the factory de-
fault "Off", no automatic connection takes place. In this case, master data is only syn-
chronized after a dispensation has taken place, along with the subsequent data trans-
fer. The factory default is 00:00 hrs.
5.3.4.3.10.7 Connection interval (LAN)
Display (e.g.):
This menu item is only available for operation with mytecalemit Cloud.
This allows a time interval to be configured at which the HDA eco connects to the web
server regularly to synchronize e.g. changes in the master data.
In addition
, a fixed
start time will need to be specified in the corresponding menu (see 5.3.4.3.12.7). An
interval of, 1, 2, 3, 4, 6, 8, 12 or 24 hours can be selected. The factory default is 24
hours.
Send delay:
Auto conn. time
Conn. interval
To Next Page
Loading...