66 44 1670 001-GB-I
HDA eco
5.3.4.3.12.5 Restart Time (CMR)
Display (e.g.):
This is the place where a time can be selected, to which the HDA eco is restarted once
a day (“Reset”). Simultaneously the CMR socket modem is restarted and the device
registers itself at the cellular network again. A periodic restart can create remedy
with sporadic connecting difficulties. In stable networks factory setting „off“ can be
used.
5.3.4.3.12.6 Transmission Delay (CMR)
Display (e.g.):
Here can be specified, after what time delay a terminated delivery will be transmitted
to the Web server. A higher value can make it for the operator possible to accomplish
several refuellings successively in order to transfer them afterwards together time
and cost-saving, e.g. A value between 0 seconds (transmission immediately after com-
pletion of refuelling) and 255 seconds can be entered. Factory setting amounts to 10
seconds.
5.3.4.3.12.7 Time Auto Connection (CMR)
Display (e.g.):
Here a time can be specified at what the HDA eco connects to the web server in order
to synchronize master data (ID’s, HDA options…). This time is used as a start time for
the selected connection interval (cf. 5.3.4.3.12.8). If factory setting „off“ is selected, no
automatic connections will take place. In this case master data will be synchronized
after preceding dispensing and involved data transfer only.
5.3.4.3.12.8 Connection Interval (CMR)
Display (e.g.):
Here the time interval for the periodic connection of the HDA eco to the web server
can be specified in order to synchronize altered master data. Additionally a fixed start
time for the interval must be input (cf. 5.3.4.3.12.7). It can be selected between 1, 2,
3, 4, 6, 8, 12 and 24 hours interval.
Transm. Delay:
Conn. Interval:
Restart Time
Time Auto Conn.:
To Next Page
Loading...