Technogym SYNCHRO EXCITE 2009 - Page 123

SYNCHRO EXCITE 2009: Service & maintenance manual - rev. 5.2
Page 7.31
Figura 7.11-10
1. Place the belt on the pinion (e)
, so that the
belt is as much
aligned as possible with the
pulley.
2. Tighten a little bit
the belt and rotate the
pulley until the belt is routing steadily on the
pinion races.
3. Once stabilized the position of the belt, check
that it works completely on the tighten device
wheel (f) during the rotation
CAUTION:
In case of the belt, during
THE
rotation, DOES NOT work
completely on the tighten device wheel:
repeat the above operations shifting the
belt of one race.
To reassemble the same belt: tighten again
referring to the marks previously done
(see at the: Figure 7.11-4).
To assemble
a new belt: refer to the
paragraph: 8.1. “Belt tension”.