SYNCHRO EXCITE 2009: Service & maintenance manual - rev. 5.2
Page 9.37
9.6. TV MENU CONFIGURATION FOR 700WTV MODELS
9.6.1. TUNING TV CHANNELS
The machine configuration procedure is invoked, when the machine is in standby mode, by pressing
the top right hand, the bottom left hand and the bottom right hand corner in sequence, as shown in
the picture below.
The machine display will shows a window from where you can access the different configuration
menus, using the proper password.
To access the menu, type in the password 2407 and press ENTER key to confirm or BACK key to
back forward.
At this point the partial screen TV is displayed on the machine display, as shown in the picture
below.
To permanently save the changes which are going to be made in this page, press “SAVE IN
EEPROM” key. To go back to the home page press “HOME” key and the configuration will
be available until the machine is restarted. This is why the following confirmation message is
displayed:
To Next Page
Loading...
