SYNCHRO EXCITE 2009: Service & maintenance manual - rev. 5.2
Page 9.47
9.9. TOUCH SCREEN CALIBRATION
The machine configuration procedure is invoked, when the machine is in standby mode, by pressing
the top right hand, the bottom left hand and the bottom right hand corner in sequence, as shown in
the picture below.
The machine display will shows a window from where you can access the different configuration
menus, using the proper password.
To access the menu, type in the password 2409 and press ENTER key to confirm or BACK key to
back forward.
To Next Page
Loading...
