SYNCHRO EXCITE 2009: Service & maintenance manual - rev. 5.2
Page 11.3
11.3. TWICE-YEARLY MAINTENANCE OPERATIONS
These operations can only be carried out by a qualified technician specifically trained by
Technogym and authorized to carry out machine installation and adjustments, as well as
special maintenance operations or repairs which require special knowledge of the machine, its
operation, safety systems and working procedures.
The twice-yearly maintenance operations involve checking the functioning, wear and tension of the
mechanical components so as to ensure the correct and safe operation of the machine.
For the twice-yearly maintenance of the machine, proceed as follows:
11.3.1. CARRYING OUT THE MONTHLY MAINTENANCE PROCEDURE
1. Carry out the procedure described in paragraph 11.2. “Monthly maintenance operations”.
11.3.2. SETTING UP THE OPERATION
Only for 500, 700 and 700WTV models.
1. Turn off the machine by placing the switch in position 0 (OFF).
2. Unplug the mains lead from the wall outlet.
11.3.3. CLEANING OPERATIONS
1. Use a vacuum cleaner to clean the interior, paying particular attention to the brake.
ATTENTION: when carrying out these operations, be careful not to damage the cables.
11.3.4. CHECKING THE WORKING CONDITIONS
Only for 500, 700 and 700WTV models.
1. Using a multimeter, check that the machine earth node is correctly connected to earth.
11.3.5. CHECKING THE WEAR OF RUBBER PARTS
1. Check the state of wear of the rubber components. Replace if there are evident signs of wear.
11.3.6. CHECKING THE BELTS
1. Check the state of wear of the belts, using the pulley to turn it by hand, paying special attention
to the edges and the inner part. Replace if there are evident signs of wear.
2. Also check the tension of the belts.
To Next Page
Loading...
