Commands Listed in Alphabetical Order
and the offset i
s set to 3.0, then input signals equal to 3.0 units are displayed
2.0 divisions above the center of the screen.
Group
Vertical
Syntax
CH<x>:POSition <NR3>
CH<x>:POSition?
Related Commands
CH<x>:OFFSet, REF<x>:VERTical:POSition, MATH<x>:VERTical:POSition
Arguments
<NR3> is the position value, in divisions from the center graticule, ranging from
8 to -8 divisions.
Examples
CH2:POSition 1.3E+00 positions the Channel 2 input signal 1.3 divisions
above the center graticule.
CH1:POSition? might return :CH1:POSITION -1.30 00E+00, indicating that
the current position of Channel 1 is 1.3 divisions below the center graticule.
CH<x>:PRObe? (Query Only)
This query-only command returns all information concerning the probe that is
attached to the specified channel. The channel is specified by x. The value of x
can range from 1 through 4.
Group
Vertical
Syntax
CH<x>:PRObe?
Related Commands
CH<x>:PROBECal?
Examples
CH2:PROBE? might return :CH2:PROBE:GAIN 1.0000E-01; RESISTANCE
1.0000E+07;UNITS "V";ID:TYPE "10X"’SERNUMBER "N/A"
for a 10X
probe, indicating that (among o ther parameters) the attenuation factor for the probe
attached to Channel 2 is 100.0 mV (assuming that probe units are set to volts).
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-115
To Next Page
Loading...
Need help?
General
