Commands Listed in Alphabetical Order
DIAg:FAILURE
S:CLEAR
This command sets and queries the clearing of pass/fail information from data
structures, not the Event Log, at the start of diagnostic tests.
Group
Diagnostics
Syntax
DIAg:FAILURES:CLEAR {<NR1>|OFF|ON}
DIAg:FAILURES:CLEAR?
Arguments
ON clears pass/fail information from data structures, not the Event Log, at the
start of tests.
OFF does not c lear pass/fail information at the start of tests.
<NR1> = 0 turns off the clearing the pass/fail information at the start of tests; any
other value turns on the clearing of pass/fail information.
Examples
DIAG:FAILURES:CLEAR ON clears pa ss/fail information on the start o f tests.
DIAG:FAILURES:CLEAR? might return DIAG:FAILURES: CLEAR 1 indicating
that pass/fail information will be cleared at the start of tests.
DIA
g:ITEM? (Query Only)
This query-only command returns the diagnostics settings. This command is
equivalent to selecting Instrument Diagnostics from the Utilities menu, and then
re
viewing the diagnostics settings.
This query-only command can be issued while diagnostics are still in progress.
Group
Diagnostics
Syntax
DIAg:ITEM? <NR1>
Related Commands
DIAg:ITEM:FAILURES?, DIAg
:ITEM:NAMe?, DIAg:ITEM:RESULT?,
DIAg:ITEM:SUBITEMS?
Arguments
<NR1> sets the index item about which data will be returned, which ranges from
0 through 15.
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-165
To Next Page
Loading...
Need help?
General
