Tektronix MSO70000 Series Programmer's Manual

Commands Listed in Alphabetical Order
Arguments
<NR3> specifies
theSPIstartbytedata.Thedatacanrangefrom0to2
16
–1.
Examples
TRIGGER:A:SPI:DATA:
START 0
sets the SPI trigger data start to 0.
TRIGGER:A:SPI:DATA:START? might return :TRIGG ER:A:SPI:DATA:START
1
, indicating that th
e SPI trigger data is s et to 1.
TRIGger:A:SPI:FORMat
DPO7000 Series only: This command sets or queries the SPI trigger data format.
Group
Low Speed Serial Trigger
Syntax
TRIGger:A:SPI:FORMat {BINary|HEX}
TRIGger:A:SPI:FORMat?
Arguments
BINary specifies a binary data format.
HEX specifies a hexadecimal data format.
Examples
TRIGGER:A:SPI:FORMAT BINARY sets the SPI trigger data format to BINARY.
TRIGGER:A:SPI:FORMAT? might return :TRIGGER:A:SPI:FORMAT 1,
indicating that the SPI trigger data format is set to HEX.
TRIGger:A:SPI:SCLK:ACTIVE
DPO7000 Series only: This command sets or queries the SPI SCLK polarity.
Group
Low Speed Serial Trigger
Syntax
TRIGger:A:SPI:SCLK:ACTIVE {RISe|FALL}
TRIGger:A:SPI:SCLK:ACTIVE?
Arguments
RISe specifies rising clock polarity.
FALL specifies falling clock polarity.
DPO7000, DPO70000/B and DSA7000/B Series Programmer Manual 2-595

Tektronix MSO70000 Series Specifications

General

Brand	Tektronix
Model	MSO70000 Series
Category	Test Equipment
Language	English